This special remote type rsyncs file contents to somewhere else. Setup example: # git annex initremote myrsync type=rsync rsyncurl=rsync://rsync.example.com/myrsync encryption=joey@kitenet.net # git annex describe myrsync "rsync server" Or for using rsync over SSH # git annex initremote myrsync type=rsync rsyncurl=ssh.example.com:/myrsync encryption=joey@kitenet.net # git annex describe myrsync "rsync server" ## configuration These parameters can be passed to `git annex initremote` to configure rsync: * `encryption` - Required. Either "none" to disable encryption of content stored in rsync, or a value that can be looked up (using `gpg -k`) to find a gpg encryption key that will be given access to the remote. Note that additional gpg keys can be given access to a remote by rerunning initremote with the new key id. See [[encryption]]. * `rsyncurl` - Required. This is the url or `hostname:/directory` to pass to rsync to tell it where to store content. * `shellescape` - Optional. Set to "no" to avoid shell escaping normally done when using rsync over ssh. That escaping is needed with typical setups, but not with some hosting providers that do not expose rsynced filenames to the shell. You'll know you need this option if `git annex get` from the special remote fails with an error message containing a single quote (`'`) character. If that happens, you can re-run initremote setting shellescape=no. The `annex-rsync-options` git configuration setting can be used to pass parameters to rsync.