vulkan-3.6.1: Bindings to the Vulkan graphics API.
Safe HaskellNone
LanguageHaskell2010

Vulkan.Extensions.VK_AMD_buffer_marker

Synopsis

Documentation

cmdWriteBufferMarkerAMD Source #

Arguments

:: forall io. MonadIO io 
=> CommandBuffer

commandBuffer is the command buffer into which the command will be recorded.

-> PipelineStageFlagBits

pipelineStage is one of the PipelineStageFlagBits values, specifying the pipeline stage whose completion triggers the marker write.

-> ("dstBuffer" ::: Buffer)

dstBuffer is the buffer where the marker will be written to.

-> ("dstOffset" ::: DeviceSize)

dstOffset is the byte offset into the buffer where the marker will be written to.

-> ("marker" ::: Word32)

marker is the 32-bit value of the marker.

-> io () 

vkCmdWriteBufferMarkerAMD - Execute a pipelined write of a marker value into a buffer

Description

The command will write the 32-bit marker value into the buffer only after all preceding commands have finished executing up to at least the specified pipeline stage. This includes the completion of other preceding cmdWriteBufferMarkerAMD commands so long as their specified pipeline stages occur either at the same time or earlier than this command’s specified pipelineStage.

While consecutive buffer marker writes with the same pipelineStage parameter are implicitly complete in submission order, memory and execution dependencies between buffer marker writes and other operations must still be explicitly ordered using synchronization commands. The access scope for buffer marker writes falls under the ACCESS_TRANSFER_WRITE_BIT, and the pipeline stages for identifying the synchronization scope must include both pipelineStage and PIPELINE_STAGE_TRANSFER_BIT.

Note

Similar to cmdWriteTimestamp, if an implementation is unable to write a marker at any specific pipeline stage, it may instead do so at any logically later stage.

Note

Implementations may only support a limited number of pipelined marker write operations in flight at a given time, thus excessive number of marker write operations may degrade command execution performance.

Valid Usage

  • pipelineStage must be a valid stage for the queue family that was used to create the command pool that commandBuffer was allocated from

Valid Usage (Implicit)

  • pipelineStage must be a valid PipelineStageFlagBits value
  • dstBuffer must be a valid Buffer handle
  • commandBuffer must be in the recording state
  • The CommandPool that commandBuffer was allocated from must support transfer, graphics, or compute operations
  • Both of commandBuffer, and dstBuffer must have been created, allocated, or retrieved from the same Device

Host Synchronization

  • Host access to commandBuffer must be externally synchronized
  • Host access to the CommandPool that commandBuffer was allocated from must be externally synchronized

Command Properties

'

Command Buffer Levels Render Pass Scope Supported Queue Types Pipeline Type
Primary Secondary Both Transfer Graphics Compute Transfer

See Also

Buffer, CommandBuffer, DeviceSize, PipelineStageFlagBits

pattern AMD_BUFFER_MARKER_SPEC_VERSION :: forall a. Integral a => a Source #

type AMD_BUFFER_MARKER_EXTENSION_NAME = "VK_AMD_buffer_marker" Source #

pattern AMD_BUFFER_MARKER_EXTENSION_NAME :: forall a. (Eq a, IsString a) => a Source #